TO REMOVE EXISTING ASSEMBLY

•      Turn the assembly with your hand, like a doorknob.   It may twist off easily.

•      If not, the assembly needs to be pushed off.   Turn kettle with spout pointing away.   Using a wooden kitchen spoon, press against the rolled edge of stainless assembly, working it around top to bottom, side to side.   The assembly should pop off.

TO REPACE WHISTLE ASSEMBLY:

•      Check inside of assembly spout collar for small black o-ring (E).  

•      Place new whistle assembly on spout.   Aligning spout indentations with indentations on the assembly spout collar push into place.

•      To secure assembly properly on spout, turn the kettle upside down placing spout opening on the edge of kitchen counter with the flipper hanging over the edge.   Using body weight to push down on the kettle, you should feel assembly snap into place. There should not be a gap between the spout of the kettle and the assembly.

TO REPLACE THE TUNING PLATE

•      Remove nut (D).   This will release the spring (B) and tuning plate (C) parts.

•      Place new spring (B) over the stud screw (A).

•      Place new tuning plate (C) on screw stud (A) with holes facing toward you.

•      Hold tuning plate (C) down with thumbs, replace nut (D) and tighten securely.

Kettle Illustration key:   A.   Stud Screw B.   Spring C.   Tuning Plate D.   Nut E.   O-ring (inside assembly spout collar)

If the kettle does not whistle, try the following:

Before water starts to boil, open and close flipper
on spout 2 or 3 times to clarify tuning plate is in place.

If you have further questions, please contact
Chantal Customer Service at 800-365-4354